Questions & Answers for: how to remove 6 7 cummins fan and shroud

...Remove four screws and separate fan clutch from fan blade. Item Part Number Description 1 8509 Water Pump Pulley 2 57632-S Screw and Washer Assembly, 5/16-18 x .62 Hex 3 8600 Fan Blade (5.0 and 5.8L) ...

...Remove two fan shroud upper retaining bolts at the radiator tanks. Lift cooling fan motor/fan blade (8600)/fan shroud assembly past radiator (8005), disengaging fan shroud from two lower retaining ...

...Remove the vacuum hoses, if so equipped. Mark them for proper installation. Pull the radiator straight up and out of the car. Reverse the above procedure for installation. Fig. 1: Radiator fan shroud ...

6: Fan and fan clutch assembly ? 4.6L engine 5.0L Engines Loosen the fan clutch-to-water pump hub retaining bolts. If necessary, remove the drive belt from the water pump pulley. Remove the fan shroud

fan connector. Remove the cooling fan mounting screws and the cooling fan. To Install: Install the cooling fan and the mounting screws. Tighten to 50 in-lb (5.5 Nm). Connect the cooling fan connector.

...6-cylinder, and I dropped a machine screw behind the bell housing of the fan. I have not been able to get it out. I think I need to take the fan and bell housing off to get it out of there. What is ...

...cummins engine. Hope this helps and have an awesome day! REMOVAL Disconnect both battery negative cables. Raise vehicle on hoist. Partially drain engine coolant into container suitable for re-use ...

fan shroud. Remove the lower fan shroud push pin retainers. Lower the vehicle. Remove the right and the left engine mount struts. Remove the left front fender upper diagonal brace. Remove the radiator

...6. Remove transmission oil cooler line from oil cooler inlet fitting. 7. Remove nuts retaining A/C condenser core to the radiator. 8. Disconnect engine control sensor wiring from the auxiliary ...

...6. Remove transmission oil cooler line from oil cooler inlet fitting. 7. Remove nuts retaining A/C condenser core to the radiator. 8. Disconnect engine control sensor wiring from the auxiliary ...