...for Ford Ranger need clutch replacement directions for 97 Ford Ranger XLT Manual 2.3 trans Remove drive shaft,remove crossmember under transmission.Remove transmission and diconnect ...
...4x4 pickup with 3.0L V6 without pulling the engine? This Seems Pretty Cut & Dry Although I Have Removed Exhaust to Gain Access to Starters on the 3.0L THIS IS Instructions PER> ALLDATA REMOVAL ...
...a bad wiper switch assembly. Removal & Installataion Disconnect the negative battery cable. Remove the steering wheel. On vehicles equipped with tilt wheel, remove the tilt lever. On vehicles ...
...water pump Disconnect the battery ground cable. Drain the cooling system. Lower the vehicle. Remove the water pump drive belt tensioner. Raise and support the vehicle. NOTE: Remove and discard ...
...cooling system. Disconnect the three way catalytic converter Loosen the water pump pulley bolts. Remove the drive belt. Remove the water pump pulley, fan and clutch assembly. Remove the intake ...
replace passenger mirror glass and motor availbable separately Removal NOTE: Do not remove the mirror assembly when repairing the individual mirror part. Individual mirror parts can be installed ...
...off.. pulled the fuses for temp solve... please help Hi, the likely problem is a failed switch. Remove the switch according to instructions below and then start the truck again. If the wipers
...INSTALLATION Loosen the wheel lug nuts. Jack up the front of the vehicle and support on jackstands. Remove the wheel and tire. Remove the brake caliper assembly as described earlier in this section, ...
...#160; Lock the steering column. Remove the front seats Remove the 2 screws and position ...
how to remove commutateur/ interuptor switch in a 83 ranger please tell where you are working,(on car) is it the engine>? the starter? the Starter solenoid. and what engines size. I think you mean ...
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions