Questions & Answers for: Dodge Intrepid remove

removal of waterpump how do u remove the waterpump from a 2004 dodge intrepid 2.7l engine? Drain cooling system. Remove radiator upper cross-member. Remove radiator fan. Remove accessory drive belts. ...

...3.3L Engine: Disconnect the battery negative - cable. Disconnect the alternator field circuit plug. Remove the B+ terminal nut and wire. Loosen the adjusting T-bolt, but do not remove it. Loosen the ...

To remove an alternator on a 1998-99 Intrepid, on drivers side To remove a alternator on a 1998-99 Intrepid, and reinstall new one FIRST OF ALL.TURN OFF RADIO SO YOU WONT LOSE RADIO CODE.FOR THE 2.7L ...

where is the dodge 2002 intrepid knock sensor remove the intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if ...

Starter replacement on 1997 dodge intrepid Disconnect battery negative cable Remove and Install Battery Cable Raise vehicle. For easier servicing, do not remove the wiring from starter at this time. ...

really need some help changeing alt on 2000 intrepid need help removeing altinator on 2000 dodge interpid Disconnect negative battery cable. Raise and support vehicle. Remove lower plastic splash ...

how to remove front axle on a 2002 dodge intrepid raise you vehicle on jackstands. remove front wheel and tire.remove front caliper from steering knuckle assembly, remove rotor from hub by pulling it ...

How to remove an alternator from a 2001 dodge intrepid 2.7l Unhook the battery. Remove the negative cable first, then the positive one. 2 Lift the front end of the car, using the jack, and place it on

...or the 3.5L so I'll post for both sizes for you: 2.7L Removal procedures Drain cooling system. Remove radiator lower hose from thermostat housing. Remove nuts from heater tube flange studs. ...

...belt and tensioners if needed. Drain the cooling system (turn the radiator drain 1 full turn only) Remove the upper radiator hose Remove the top radiator support Remove the two 10mm head bolts from ...