Questions & Answers for: remote start wire starting vehicle

...remote start portion of the system..you may have kicked it / bumped it with your foot, causing the remote start portion to be deactivated. Just flip the switch the opposite way and try again.. Also, ...

...remote start has a remote timer, that you can program the remote start to start every hour for like 5 minutes, or there is an activation wire on the remote start that is getting grouned somehow and ...

remote starter.. once the car is started, it will then try to keep restarting itself and it makes that horrible noise. Any help? Either the auto start is defective or the wire from the control box, to

remote start was installed.Is this an issue with the transmitter being close to the car antenna? No, the transmitter for the remote start won't interfere with your radio receiver. It's likely that the

remote start put in yesterday. started truck this morning fine with it, but when got into car no heat was on. as soon as i put the key in and turned it to ignition, heat came out. any ideas why heater

...remote I would start with checking the antenna. It should be mounted on the windshield probably at the top in the middle. Check the antenna wiring and make sure it is not all bundles up it should be ...

...remote start I have installed a prostart ct-3460tw car remote start in my 2000 jeep tj sport manual trans. I can't get it to work. I bought it use still in the box unopened. My issue is the yellow ...

...remote start nothing yet On some remote starters, there is print on the back of the remote starter itself. It is hard to see with it being black raised text on a black box. If not there, sorry DEI ...

...remote start it, it starts but it sounds like its trying to start it again and then shuts off the motor is running for a few seconds then it tries to start it again..then it shuts down by itself If ...

...start. I have a GMC Yukon that has an APS997 installed. I do not have a remote and have never used it. I have had the vehicle for many months, starts and runs no problem. But now suddenly it has ...