...bracket. Remove the powertrain control module (PCM) electrical connector bolt. Pull the connector from the PCM and position aside. Remove the two PCM bolts. Remove the PCM relay. Remove the three ...
bracket that holds the filter in place and install the new filter. I do suggest that you remove the fuel cap to try and relieve some of the fuel pressure built up in the lines before disconnecting the
...turn signal relay located in a 1995 mercury villager? http://groups.yahoo.com/group/villagerquest/ behind dirver side kick panel. remove bracket with 2 10mm bolts on it. has 3 relays on it. Lucas ...
...relay, just did this to son's car (Thunderbird). Most vehicles are in fuse block but his his was on bracket behind dash above accelerator pedal, very hard to get wiring clip off and expensive, $38, ...
...relay pane and start the engine. Let it idle until it stalls, and then crank the engine for about 5 seconds to make sure the pressure was released. Turn the ignition off. 2Disconnect the negative ...
bracket assembly ----------------------------------------------------------------------------------------------------------------------- Principles of Operation Perimeter Anti-theft The perimeter anti
relay is above and behind the fuse panel on the dash. 2 relays and turn signal flasher in same area. Turn signal light on to locate flasher. 2 bolts hold bracket with relays & flasher. gerry http:
Question about 1998 Mystique
...bracket relay location,cannot find a fuse listed for cruise control Passenger compartment fuse box. The way I test relay is to substitute with known good one and check operation of system. I usually ...
Question about 2002 Villager
...bracket securing it on the back side. An inspection mirror comes in handy to locate these types of fasteners. You may be able to locate it by running your hand along the back side of the plenum 93 ...
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions