Questions & Answers for: regulator test

Question about 2001 Tribute

1 Answer

...Test Pin 47 (EVR) and EVR circuit at the EGR Vacuum Regulator solenoid vehicle harness connector. Is resistance less than 5.0 ohms? Yes No GO to HE113 . SERVICE open in EVR circuit. RECONNECT all ...

Ad

Question about 2002 FXDWG Dyna Wide Glide

1 Answer

...regulator, test continuity from each conductor to ground on the stator, if you have continuity STATOR IS SHORTED... if you test voltage OUTPUT at the stator, it should be around ten volts AC! NOT DC! ...

Ad

...Regulator Test: Each of the following tests isolates the regulator only, so if any of these tests fail, the regulator is at fault. Identifying Wires: Battery Charge Lead- Wire going from regulator to ...

Question about 2002 YZF 600 R thunder cat

1 Answer

...before replacing the wire, as the reason for the wire burning out was probably because the regulator has a short circuit.  Someone who has an OHM meter can test to see whether it is short or

...Regulator Test: Each of the following tests isolates the regulator only, so if any of these tests fail, the regulator is at fault. Identifying Wires: Battery Charge Lead- Wire going from regulator to ...

... unplug the regulator wire at the alternator connection at the front of primary. With a test lite attached to a good ground, test the regulator pins, if the test lite glows replace regulator. Good ...

Question about 2004 FLHTC - FLHTCI Electra Glide classic

1 Answer

...regulator and test between either or both ends of the wire i.e. from the regulator wire harness connector terminal and a known good ground and/or the main fuse terminal end of the wire and a known ...

Question about 2004 FLHTC - FLHTCI Electra Glide classic

0 Answer

...Regulator Test: Each of the following tests isolates the regulator only, so if any of these tests fail, the regulator is at fault. Identifying Wires: Battery Charge Lead- Wire going from regulator to ...

...Regulator Test: Each of the following tests isolates the regulator only, so if any of these tests fail, the regulator is at fault. Identifying Wires: Battery Charge Lead- Wire going from regulator to ...

...Regulator Test: Each of the following tests isolates the regulator only, so if any of these tests fail, the regulator is at fault. Identifying Wires: Battery Charge Lead- Wire going from regulator to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...