reed petals.replace if worn or broke.reassemble.try to start bike.if no start, chek exhaust valve system to see if it may be stuck open from gumming up, or broken.ex valve system is kinda complicated,
does anyone know what the problem may be ? Check your compression,,Maybe you blew the rings,or the reed valves,,,oh,,you did check that you have fuel,,right
...reed valve is bad on kx 125 looks to be not broken or chipped or bent open in any way... The reed valve assembly should hold solvent withot leaking. Remove for test. Disassemble and clean reeds and ...
reed valve is good, air cleaner good, new spark plug, i pulled the exhaust valve cap off and black oil came out?? would it be the exhaust valve? shouldnt the valve move when you kick start it? or does
...under load, the bike misfires pretty bad. I cleaned the carb, installed new plug, and the reed valves look ok. Any idea?? muffler bearings ...
...reed valve looks good why wont it run properly Who put the new crankcase seals in your bike? Sounds like your sucking oil out of your crankcase if it is blowing all that smoke.just fixed Cr125 doing ...
my kx 2005 was runnin great them started bogging randomly changed reeds top end and cleaned carb... Well - not knowing the condition of the bike it could be a lot of things. I would start with a fresh
...all jets including the pilot air screw, idle speed screw, pilot jet, floats, inspected the reeds and throttle valve. any info can help, thanks I would check the compression of the piston,
can i put a bigger reed valve in my kx 125 No u can't.
Question about 2003 KX 125
reed valve block. Can anyone explain how this can happen? 2003 KX125 glycol seeping out of vent line underneath reed valve block. I replaced the crank bearings Resealed case halfs with Kawasaki liquid
Usually answered in minutes!
239 Questions
29 Questions
21 Questions
7 Questions