...reed valve. I took it off and gained alot of power back but still not perfect. It still had a stumble from idle to low rpm before it caught itself and then it ran good. I rejetted the carb from 230 ...
...reed valve block and check the condition of the reeds(if you can see daylight through the valve seat)ie between the reed valve and the base block,the reeds may need replacing,this may also explain ...
...you mean not to start they could. a reed valve is simply a one way valve that captures the air fuel mixture in a two stroke motor forcing to go into the combustion chamber rather than back out the ...
...what should i do? If this bike is carburettored, not EFI then you have damaged / bent the reed valves in the carby. Remove carby which has the reed valves on the inlet side and you will see ...
does yz80 have a ridvalve? reed valve, or reeds, yes.
reed valve but I guaranty a dodgy reed valve will make running and tuning the bike a nightmare. Your reeds need to seal perfectly and open and close about 2-3 times a second so if any cracks, holes or
...reed valve. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day. YZ250 bad reed Yamaha 2 Stroke 1999 ...
...2 stroke and has on valves per say. It has a reed valve located between carb and head. Lots of times they need to be replaced or re-clearance (Make sure they are free of debri and flat on the
...a K n N type to get more fuel and air in to cope with unrestricted exhaust ! Does the engine have reed valves infront of the carb ? could do with opening to max amd fit fiber reeds ! have fun
when you get it out) it will allow too much fuel/air into the engine. The reed valve(s) are located between the carburetor and the engine. The individual reeds are available as well as the entire unit
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions