Question about Cummins 4.0 KY-FA/26100 RV QG 4000 4000K Gasoline Generator Micro
Reed valve located in valve cover That sounds like the reed valve sticking or dirty. You will need to take out the reed valve, clean and re-install. Be aware that a small amount of oil is common, also
Question about Cummins 4.0 KY-FA/26100 RV QG 4000 4000K Gasoline Generator Micro
...Reed valve stuck open ,but I was hoping that someone could provide me with a picture that showed the correct position that the reed valve needs to be. I can provide you with a picture, can you post ...
no fuel to carb on lp will start then die then wont try again to start, fuel valve will open w/o pressure but will not with fuel pressure Check LP pressure the obvious, but it sounds like the demand ...
Question about 2500 Watt LP Vapor Generator - 2.5 KVFA/26120
onan generator KVFA2.5 lp no fuel pressure to carb. Fuel salve will open w/o fuel pressure but not with fuel pressure Fuel valve not opening when line is pressurized but works fine on bench test Have ...
onan generator microquiet 4000 runs for 3-5 minutes then stops no fuel and the fuel pump quits will not prime until it cools down Check the pickup tube in the vehicle, the fuel pump is suspect. If you
Question about Cummins 2.8 KV-FA/6050 RV QG 2800 EVAP 2800K C.A.R.B Compliant Ga
onan 2800 generator sops when a/c is turn on onan 2800. runs find until a/c is turn on gen stops a/c is only then connected While you didn't indicate the btus of the HVAC I assume it worked before? ...
Question about MicroLite 2500 & 2800 LP Gas Generator
My Onan 2500 Microlite LP starts when cold, but soon quits until it gets cold again. I think that the fuel inlet valve needs and adjustment. How is this done? I would not adjust it, I would say the ...
Question about Cummins 7.0 HGJAB-6756 RV QG 7000 EVAP 7000K C.A.R.B. Compliant G
valve adjustment for onan 7000 generator What is your question specifically? how to adjust them? how to turn the engine over? Be more specific
Question about CUMMINS 4.0 KYFA/6747 - Cummins MicroQuite Generator, 4000 Watt, Gas C.A.R.B. 4.0 KYFA/6747
My onan 4.0 grenerator motor will not idle and it is back fireing while trying to run is in the valves I have taken the carb apart and cleaned it the float and needle valve where in great shape and I ...
Usually answered in minutes!
13 Questions