Questions & Answers for: reddy heater ignites top cover

...REDDY HEATER 55000 BTU. IT ALWAYS RAN FINE BUT NOW IT WILL START UP THEN IT SHUTS OFF AND BLOWS ALOT OF SMOKE. IT WILL KICK BACK ON AND SHUT OFF AGAIN BUT ITS TOO MUCH SMOKE. SO IM GETTING FUEL AND I ...

top cover off and observed the system on startup. The fan comes on but there is NO spark at the plug and NO ignition. What component may be bad and where do I get parts? Check: be sure the transformer

...heater and it runs fine with the top cover off.But if I put the cover on it will go out is less than a minute and trip the reset. Determine if there is spark at the plug no spark? check the ...

...heater r100a blows fuel but will not ignite if i lift one side of top chamber cover it will fire up the air pressure is not set correctly.take a look at the back plate very closly and check to see if ...

...top cover on the heater. Turn the heater on and watch the back of the burner area. Do you see any fuel mist coming from the nozzle? Do you see the ignitor sparking or glowing. Providing you see the ...

Reddy Heater 55,000 has trouble igniting with top half attached Reddy Heater 55,000 has trouble igniting with top half of outer tube attached. When top half of tube is off. Heater runs great. I'm ...

top cover off the heater works fine, but the minute I put the cover back on it does not want to ignite. I'm stumped. Does your heater have an oxygen sensor on it? If so try gently cleanig dust,lint or

...top of the heater and turn it on. Look for the igniter to start sparking if it uses the spark plug type igniter or if it uses a HSI type, look for it to start glowing. Next, use a flashlight to look ...

...are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater... Reddy Heater - Troubleshooting Torpedo Heaters Torpedo Heater Pump Pressure Adjustment heatman101

...heater start with the top cover removed?? If so try closing down the angle of the fan blades a little, but not too much, to reduce the air forced into the combustion chamber. If the heater will not ...