Questions & Answers for: Buick rear wheel

...rear wheel bearings on buick rendezous I was trying to replace the rear wheel bearings on my 2006 buick rendezous but, (2) of the (3) bolts holding the wheel bearing to the axle were blocked by part ...

rear wheel drive. 3 things it can be. propshaft donought bearing if fitted. 2 wheel bearing. 3, rear diff, been ran low on oil, the bearing has fried. if you go under the car see if you can wobble the

Rear wheel will not rotate after spinning on snow/ice On some snow and ice in the driveway and the wheels spun a bit which locked up the rear wheels. Was able to free one of the rear wheels to rotate ...

...rear wheel drive? If rear wheel drive it will be on the passenger sive of engine between engine and firewall( tough to see ).If it is front wheel drive the it will be on the drivers side towards the ...

What it the silver tube on the rear brakes? part says Delphi than numbers 2076/2 and .3/3.0 and theres 2 on the car. one for each rear line. If you are talking about the tubes in the brake lines ...

...wheel bearing Check rear brakes and that also means the emergency brake shoes that are located under the rear brake disk . and also check the rear shocks It's something in the back wheels making the ...

...rear wheel drive. the fluid leak at the wheels is probably brake wheel cylinder/caliper or brake flex hose. check brake fluid level if its down then check for brake fluid leak if not then you will ...

...rear right wheel locked up. There was a small puddle of fluid near the inside of my rear right wheel. And the wheel seems to be locked. I didn't have any problem until now. The problem seem to happen ...

rear wheel bearings being worn to the stage of needing replacement. If you have around 100,000 miles or more on the vehicle that is also likely although normally I would expect the front to wear first

...rear wheel at the axle and you will feel and see several lines going to the back of the wheel. One will be a thin steel tube ( hydralic line) NOT IT. Another will be a flexible cable going into the ...