rear turn signal on a 2007 impal Open the trunk, inside the trunk is a liner. Pull the liner back and you'll see the wiring going to the back of the light. Remove the light bulb retainer by unscrewing
How do I change turn signal bulb? remove headlamp and go in from rear if in back remove tailamp and go in from rear
rear left tail light wont blink Sounds like your turn signal is out, or if you are referring to your brake light blinking, then you need to replace your brake light bulb, they have two seperate ...
Question about 2007 Impala LS Sedan New Cars
Turn Signal on right rear not working, indicator on dash blinks quickly. Bulb does not seem to be burnt out It could be the socket that the light plugs into I have found a few of them to be a little ...
Question about 2007 Impala LS Sedan New Cars
turn signal not working The rear driver side brake light and turn signal does not work, but when I checked the bulb it was working just not when I press the brake or use the turn signal. The left turn
Question about 2007 Impala
...rear driver side brake light and turn signal does not work, but when I checked the bulb it was working just not when I press the brake. The left turn signal on the dash also blinks rapidly. Sounds ...
Question about 2007 Chevrolet Impala LT
...rear turn signal lamps supply voltage circuits cycling the lamps ON and OFF. The BCM also sends a message via GMLAN to the instrument panel cluster (IPC) to cycle the turn signal indicator ON and OFF ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions