Questions & Answers for: rear sprocket Cars & Trucks

...rear camshaft sprocket. 3.Run the timing belt onto the water pump pulley, the front camshaft sprocket and the timing belt tensioner. 4.Apply force counterclockwise to the rear camshaft sprocket with ...

Ad

Question about 1993 Eclipse

1 Answer

...rear) silent shaft (oil pump sprocket) is in the correct position as follows: Remove the plug from the rear side of the block and insert a tool with shaft diameter of 0.31 in. (8mm) into the hole. ...

Ad

rear camshaft sprocket. Route the belt to the coolant pump pulley, the front camshaft sprocket and the timing belt tensioner. Apply force counterclockwise to the rear camshaft sprocket with tension on

...rear camshaft sprocket timing mark should align with the generator bracket timing mark and the front camshaft sprocket timing mark should align with the inner timing belt cover timing mark. If the ...

Question about 1997 Caravan

1 Answer

...rear camshaft sprocket timing mark should align with the generator bracket timing mark and the front camshaft sprocket timing mark should align with the inner timing belt cover timing mark. If the ...

Question about 1997 Caravan

1 Answer

...rear cam. Align the cam sprocket marks with rear timing cover. Because this engine is mounted at a 60 degree angle, you must use the marks. Rear cam should feel compression while front cam is

Question about 2000 Caravan

1 Answer

...the word "up" reading horizontal, and the horizontal marks on both sprockets are lined up with each other. The rear cam sprocket is usually set one tooth of, then rotated with belt to take up

Question about 2000 Caravan

2 Answers

...lbs. (47-54 Nm). Check to make sure that the rear face of the camshaft sprocket is flush with the camshaft end. Fig. Fig. 7: ALWAYS double check timing mark alignment before installing the timing ...

Question about 2001 Ranger Regular Cab

1 Answer

...rear cassette chain, tensioner and sprocket Jackshaft sprocket and chain on the engine and remove the tensioner pin  Torque the jackshaft sprocket bolt in 2 stages: 32-35 ft. lbs. (43-47 Nm). ...

Question about 2001 Ranger Regular Cab

1 Answer

...rear sprocket. If you can pull it away from the sprocket and see a fair amount of space between the teeth, replace the chain. Also both sprockets at the same time. Repost another question if more ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...