Questions & Answers for: Chevrolet Tracker rear end

Question about 2000 Tracker

2 Answers

...rear differential, the diff cover must be removed. You will find a small bolt on the left side of the carrier that retains a large pin that goes through the spider gears. To remove axle, remove that ...

Ad

...be the rear end going out. Mine has been replaced twice with used rear end. You should be able to confirm it by looking at the rear tires both sides of tire for an oil leak or wet spot on tire or

Ad

...rear end seal on 2000 Chevy Tracker I need to know how hard it will be to change a rear end seal on a 2000 chevy tracker, and possible show a diagram please. ...

Question about 1999 Tracker

1 Answer

...the tire and do both sides then with a tape measure check on the two lines on the wheels front and rear it should be no more than 1/8 towed out in the front if it is more adjust then take it to a ...

...rear end of my chevy tracker have the whole rear end out now how do i take it out the shaft take off the housing cover in the middle of the rear end and to each side there is a retainer clip for each ...

...REAR END ON A 2003 CHEVY TRACKER? they have a large screw in the middle of the hub cover with a metal cap in the very center of the hub with a screw driver flat tip take cap off and you will see the ...

Question about 1999 Tracker

1 Answer

...rear end I am interested in buying a tracker but when i test drove it that was a slightly loud humming in the rear end and i slight shaking. After i test drove it i check the pumpkin and it was not ...

Question about 2000 Tracker

1 Answer

tires are wearing on rear on insides The toe end,or the camber is out,have it aligned to solve this problem,please rate.

brake pedal goes to the floor , replaced master cyclinder , replaced front pads , adjusted rear brakes , bleeded all the lines , still the same . you need to check and see if these have a brake pedal ...

Question about 1999 Tracker

1 Answer

rear end how do i get the dif cover off?! if there is no cover with bolts then you will need to pull the third member to gain access to the inside of the housing which means you have to pull the axles

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...