Questions & Answers for: Chevrolet Chevy rear end

...end. Remove Drive shaft set aside. Use some 4 X 4 and 2 X 4's and block up the engine at the rear. You will need a transmission hoist - can rent these Take off speed cable Take off shifting cable and ...

rear end has limited slip seems to have posi track 1985 chevy truck what chevy trunk has a positive track rear end

...rear end. When I turn I have a 71 C10 with a posi rear end. When I turn and accelerate the rear end make a clunking/slipping noise, but straight take offs are fine? Is this common with posi rear ends ...

1957 chevy belair rear leaf spring instalation. does the short end go toward the front or rear usually the short goes to the front, just in case measure the distance to the axle to the front eye

...rear end. Don't know what year trans but have some part numbers. GM 25 3743368, 2110 8845157 The numbers E8551GM and E856GM are also stamped on these parts. Where do I go to try to identify this ...

rear end works great when in 2wd sounds like the gear ratio is different front and rear,tires all the same size? If you want to check the ratio,just mark a spot on a tire ,roll the truck till the mark

...rear end It is a Chevy truck. The four leaf sring clamp nuts need to be removed (rear end supported with a hydraulic floor jack or equivalent), disconnect the drive shaft, once again four nuts on two ...

silverado 4x4 shakes very bad when i let off the accelerator, speed doesnt matter and it doesnt do it all the time but when it does its scary ck drive shaft carrier bearing and u-joints, then rear end

their is bangging sound in the back of my truck it is 2000 Coming from the rear end?Limited slip rear end?Need to change the fluid if not worse then that.

...rear bench seat cushion are two stamped metal "hooks" that secure the bottom of the seat to the floor. These hooky things and their matching loops are about 12 inches inboard from the far end of each ...