Questions & Answers for: Chevrolet Silverado rear diff fluid

...rear-end axel remove wheels, brakes, diff. cover, and slide out spider gear pin. the pin holding the little gears in place in the diff.. this probably has a screw or bolt holding it in. remove spider ...

Ad

Question about 2004 Silverado

1 Answer

...rear tire. first drain fluid and remove diff cover take off tires theres a c-clip in the diff that needs to be removed so you can take the axles out the seal is behind the axles pull old ones and ...

Ad

...diff. Inspect the bearing area of the shaft for rust, pitting, or scoring. Remove the old seal and carefully install the new one. Reverse proceedures to install. Take care to note the "C" clips and ...

...diff with a spec fluid-- i havent changed the fluid yet---- sometimes if the lmtd slip is put under ALOT of pressure all the time, the clutch will burn out and you will have to replace it. you could ...

diff case install tire your good to go Take wheel off, Undo the brake caliper, remove rotor, (Cant remember if you have to remove the parking brake shoes or not) If so do that next, ( If equipped with

Question about 2001 Silverado

1 Answer

...rear diff breather hose really would not do good breathing in vapors. Last time I saw one it was secured to the inside of the frame other times it is just secured to the underside of the bed

rear diff. fluid chage help Inspect spyder gears in differential. Make sure you pop the rear diff cover, and not only replace the fluid, but I take a good strong magnet such as from an old speaker and

...fluid before beginning. Jack the car up so that the two rear wheels are about six inches above the ground. Slide under the right rear wheel and look at the back of the brake system for a small bleed ...

Question about 2001 Silverado

1 Answer

pushes to the floor have him,her hold until you tighten. Repeat on same screw until just fluid comes out. Repeat same process on left rear, then right rear, then right front. Needs to be in that order

...rear shaft or use a shaft fluid cap > remove torque converter bolts> remove housing bolts that connect trans to engine >remove cross member use floor jack or similar to lower trans don't ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...