Questions & Answers for: Jeep Wrangler rear bearings

...rear end on my jeep has bearings on them and i want to reuse them how do i get them off without damaging them Axle bearings? If so then you used a slide hammer with the half moon shaped adapter. the ...

rear diff fluid and gasket, check fluid again and it was still a milky color and the whine did not go away Sounds like there is water getting into the diff. Most of the time it is from the vent on the

Jeep 1992 Wrangler - Replacing rear differential The drive shaft broke off my jeep b/c the bearing to the yolk in the rear differential busted. I live in the Virgin Islands where their are plenty of ...

Vibrating when first start to move. told it's the flex plate. This started after I had my rear main bearing leak fixed and transmission filter replaced on my 2003 Jeep wrangler. Could the machanic at ...

loud nosie coming from rear left drum there is a loud noise like a tin can being ground up in the left rear brake drum area. it only happens if i drive longer then 20 miles and only when i stop after ...

i have a newer jeep wrangler early 2000,s how are the rear axle held in to the differential carrier?? im trying to repair a rear axle seal There are two styles, typically. If you do not find a bearing

removed, and while its out, go ahead and replace the clutch, resurface the flywheel and replace the rear main oil seal

...rear end. (make sure it is on jack stands) Remove 8mm bolt. Slide out the keeper pin( big round slug in center of the diff.) Slide the axle closer to the other, just enough to pull a little c-shaped ...

...REAR WHEEL BEARINGS To replace the bearings, you need to first remove the axles by removing the diff cover, taking out the small bolt or drift pin that holds the spider gear shaft in place, removing ...

rear of vehicle seems to squirm back and forth at any speed but notice it mostly above 50 ! It also does it when the cruise control is engaged and disengaged. Sounds like either a bent rim or loose or