Questions & Answers for: Chevrolet Blazer rear bearings

Question about 2001 Blazer

2 Answers

...rear end, just behind the yoke. Could it be a bad bearing or is it most likely the ring and pinion are bad this means the ring and pinion gear are worn, but when u do the gears u will need to also ...

Ad

...Rear End repair shop to do this.If you are very mechanically inclined and have all the specific tools like a slide hammer, bearing puller, bearing installation tool, etc. If you have tools like this, ...

Ad

Question about 1989 S-10 Blazer

1 Answer

96 chevy blazer rear axle bearing/seal r/r i keep throughing out my rear axle bearing does the axle bearing/seal kit need to be pressed on the axle No. Did you run some emery cloth along the race ...

...And inspect carefully the carrier bearings. This job requries resetting of clearances, and if done incorrectly a noisy rear end will result. Another option is to replace rear end with used

My rearend( I think ) is making a roaring noise and fills like it isn't getting power at times when I use the accelerater Have the rear-end check out (3rd member) center part of rear-end housing, and ...

...bearings in the rear differential remove your inspection plug and see if there is a bunch of metel shavings on the plug there probably be a little then remove rear cover and see if there is pieces ...

Question about 1996 Blazer

1 Answer

i have alot of grinding out of the rearend Sounds like bearing or bearing are gone out. Jack up vehicle, check fluid level. Grab one wheel and spin it, listening for noise from wheel bearing area and ...

Question about 1995 Blazer

1 Answer

...bearings in rear end could be axle bearing of carrier/pinion bearings while driving shift weight of truck side to side see if noise changes if so it is axle bearing if not then most likely ...

Question about 1987 Blazer

1 Answer

simply need to get my caliper and rotor off to grease my rear bearing. What flippin size is the allen key for the caliper bolts? 3/8". you cant grease the rear wheel bearing. its lubed from the rear ...

...rear end. Pinion or wheel bearings. Have a good independent shop install noise sensors located at each bearing location to verify which one it is. Oh yes I'm assuming you have done the obvious check ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...