Questions & Answers for: Nissan Pickup ready

have a miss from 2000 rpm and up and it's not all of the time but most of the time. I am just about ready to take it to the Nissan dealer but really would rather save the money and do it myself. Could

...check i have a 96 nissan D21 clear the check engine and drove ot for 50 miles and monitors not ready drove 400 miles and monitor still nor ready any sugestions amına koyduğumun ...

5 sp manual transmission getting ready to go out (91 Nissan 2WD) no aberrant sounds in 4th gear but in 5th some whirring and creeking and grinding.....(is it a bearing going out?)...also in 1,2 3 ...

TRUCK CUTS OFF WHEN I GET READY TO STOP. 1991 NISSAN PICKUP 4 CYL. TRUCK RUNS FINE. WHEN BREAKING TO STOP, IT GOES DEAD. HAD PLUGS AND WIRES REPLACED. FROM HIGH SPEED IT JERKS WHEN SHIFTING DOWN, THEN

...do not know how to unlatch the grill in the middle of the grill. I no longer need assistance. I all ready new about the plastic screws, and I managed to unlatch the one latch which was giving me a ...

... needs to be raised on the lift and adjusted for proper adjustment. usually if it is too high it is ready for ...

and or remove spark plug and put plastic straw in hole to see if piston is at TDC (top dead center) ready to fire on compression stroke. After setting timing always rotate engine 4 times to bring back

...it in this position, take another common/slotted screwdriver and take the C clip off. When you are ready to reinstall the handle, simply snap the C clip in place on the handle and then just tap the ...

when starting, clutch down 1st gear turning key truck jumps forward, will start but need to be ready to take off in gear that started in. starts fine in neutral.but won't go into gear without grinding

1997 Nissan Truck didn't pass emission test, readiness monitor not ready When "Readiness Monitors" are not ready that usually means that someone either disconnected the battery or the computer was ...