Questions & Answers for: Toyota ready

...Toyota sienna, took it to inspection yesterday to get inspected and didn't pass results Cat not ready and evap not ready, inspector tell us run the car couple miles and bring it back after around ...

...Question: I replaced all 4 O2 sensors on my 1996 GMC 5.7L Yukon. My scan tool shows "Sensors not ready to communicate or available" for #2 & #4 ( downstream. #1 & #3 are fine and reading. ...

For inspection ...it reads "not ready" Brought my matrix for a NY state inspection and the readings came up as "not ready" the only answer the dealership could give me was that I didn't put enough ...

...how do i do that hi first you will a spark plug spanner make sure you have the correct replacements ready before fitting them check the plug gap is correct you check these with a set of feeler gauges ...

...andthrotle position sensor but still has problem and wont pass inspection.. said cat converter not ready sounds like the IAC (idle air control valve) or possibly a vaccum leak. As far as the cat. ...

...car there are 3 low beeps coming from the left hand side of the car, Power on the car to IG-ON or READY. IG-ON will do for this purpose. Using the Trip/ODO button, set the Trip/ODO display to ODO - ...

toyota t100 obd not ready Vehicle Inspection Report of a Toyota T100 Problem stated below. OBD System - Readiness Status Catalytic Converters: Not Ready Heated Catalytic Converters: ...

I HAVE TOYOTA ESRMA HYBRID IT DOES NOT START OR CRANGING THE READY IS NOT LIGHTING IT DOES NOT START,READY LIGHT IS WORKING did you look in the FSM, for no starts? or at alldata.com, maybe join a real

...Corolla. Went for emissions test after replacing the battery and we failed the test. It showed 'Not Ready' because of the new battery. What is the drive cycle for the above. You must perform an OBD2 ...

2006 toyota highlander hybrid ready light won't come on ready light? must be some Hybrid , thing? so is car dead or only a lamp fails. where is this ready lamp in the cluster>IP