...then maybe. If it is just the mirror, just go to your neighborhood auto glass shop and but a "Ready-Cut" mirror for a small amount of money. they come already cut to fit perfectly. As for ...
...the truck. Then have four guys to lift on all four corners and set the bed on the stand you have ready. The bed is heavy! And there is the fuel pump! Replace with the new and take care to put the ...
...pump It is a bit easier to remove the fan clutch nuts with the belt on but if you have it off already it still is the same procedure. Once you remove the upper shroud half (I think there are 5 ...
Sensors not ready 2001 Chevy S10. I have driven more than 500 miles and sensors still read not ready. 02 Sens Not Ready, 02 Sens Htr Not Ready, Catalyst Not Ready. This is the heater side of the ...
99 safari egr and o2 sensors won,t show ready. i did 200km and every drive cycle procedure i could find. 4 moniters not ready....egr,cat.,evap,and o2 . i only need egr,cat, or o2 to pass. look for ...
2005 gmc canyon computer not ready and not reading codes to try to pass GA emmissions..check engine lite was on...i disconnected battery..have driven +200 miles..cannot pass due to only thing not ...
...the vehicle over 55 mph for 20 minutes. With an inexpensive hand held scanner you can check the ready/not ready status of the EGR, EVAP, and O2 system. BTW, if you unhook the battery for five ...
Question about 2000 Jimmy
I HAVE FAILED EMMISIONS PASSED ALL BUT READINESS RESULTS. CODE 99999..OBD Read the article in the link below and it will explain how the readiness monitor tests ...
Question about 2006 Canyon
...line flare nuts on the end of the lines? I see nothing that looks like a 'plug'. You buy the lines ready made or you have them made a garage, using a brake line flare tool set. eBay sells them ready ...
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions
