Questions & Answers for: rca preamp

RCA Preamp is putting out a signal that has no low frequency audio in it because it has some sort of a passive crossover in it. Is there any way to make my sub able to be played through the RCA Preamp

...rca jacks label preamp out or preout. I is no switch to turn your power amp on while leaving your preamp on, but you can switch the speaker a and or b switch off if you like. If you are refering to a ...

RCA input left "white" right "red". The preamp has plenty of input and output jacks, the proper connection is the one labeled "PREOUT" which usually located far from the group of rca jacks "PHONO,TAPE

...need a bit more gain out of your ipod. There are lots of solutions. Google preamp or check out Sound Shocker by PHP Audio. Get a headphone-to-RCA male adapter and run it to any input EXCEPT

...preamp for my record player and can't seem to find out whether or not i can ground my record player using it. Also need to make sure that is has RCA imput and output. thanks David According to this ...

...RCA from the Preamp Main Out to the C372 Aux In to hear any sources attached to the preamp. Or, if you don't NEED the preamp because you don't have a turntable,ditch the preamp and connect the sub ...

Preamp? It is RCA out on the Preamp, but I don't know what the input on the S250 is? There is just one plug per channel? Yup, one cable per channel, RCA at the NAD end, too. What's the mystery

...RCA preamp outputs and 2 RCA sub-woofer preamp outputs.  These outputs connect to amplifiers if you care to use them.  You can read all the specs and download the users manual at the ...

...a technics turntable using a phono preamp plug the RCA phono plugs from tuntable into preamp in & then plug the preamp out to an open RCA plug on your amp or receiver like tape 1 or CD or

RCA cables should connect the receiver and equalizer. Connect one pair to the preamp output channels and the other end to the left and right input channels on the EQ. These are on the back side of the