Question about Heatpro 100,000 Digi. Thermostat Heat Pump
...it to corrode. I suggest moving one or the other if this is the case. If this helps you please rate me as high as you can If not please post back with an extended detail of your problem. thank ...
Question about 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame
...really moves the water if motor is ok then it would most likely be this . Thanks for useing fixya Rate ...
Question about 1.5 Hp Northstar High Performance Pump
...take it in and rebuild hole thing as you will be better off in the long run. THANX FOR USEING FIXYA RATE ...
...Rate 40gpm, Max Working Pressure 50psi) Heater - Hayward H1501 Will I be okay with the 1/2 hp motor? If not, can I install a bigger motor on the pump (Model 2600X5A)? Thanks, Wayne BC, Canada ...
inground with hayward pro series we replaced lateral and sand all was fine 2 months have passed and now i have sand in pool again Thank you for posting your question here on Fixya.com. First of all, ...
I just bought and installed a new intelliflo variable speed pump and now my Hayward pool sweep does not move to the shallow end. It only cleans the deep end and even that is not cleaned well. It seems
...rate, A 1.5 pump, rule of thumb, will move 50 gallons per minute. It appears from your picture that you have a 300 # sand filter. If this is the case, you have plenty of filter capacity. Your 1.5 hp ...
Question about MaxFlo Pool Pump ( Max Rated) | 10hp SP2807X10
Pump only hums when turned on. Thank you for posting your question here on Fixya.com. It could be the pump is bound up but it is more likely the motor is failing. It may be a small part such as the ...
Low flow rate all lines and connections seem to be clean and the pump sounds fine. Yet the flow rate is almost none. The pre-pump filter basket never really fills with water either.It seems to have ...
Question about SAND FILTER, PRO SERIES
...Your pump should also have a HP rating stamped somewhere on the pump. If you do not use the same rated pump, the result could be improper water flow rate, improper back pressure, or other
Usually answered in minutes!
3 Questions
1 Questions