...RAID BIOS UTILITY I sent this to Asus support Having Problem with installing RAID in ASUS P5KC Looking at Mother board book have selected raid as controller mode But can't get into the JMB363 RAID ...
...doesn't recognize the drives. It does see them when they are set to normal (non-RAID). Is this a BIOS issue or is the driver not 48-bit to recognize >137GB? Did you run the RAID configuration
...Raid Utility My raid utility is not listed in the bios and i need to disable it. i installed a 750gb sata drive and the raid utility keeps trying to set up a raid array using 2 drives as one drive. ...
...raid configration utility. From there "delete raid" -> create new raid volume and select raid type as raid 0. Then boot from RDVDs and install operating system.Let me know if there is any trouble ...
...raid utility. Once in the raid utility u should see a function to Break or Delete the raid group. Do this and then the drive should revert to a non-member disk and therefore a single drive. Once this ...
...are mirroring or striping! Some systems have a GUI RAID utility as well for setting up the drive(s). Depending on the size of the drive(s) you're using it can take a while for the setup to
Question about Barracuda 7200.10 320 GB SATA Hard Drive
...raid utility. I am trying to clone my ide c drive onto a new seagate sata Some older mainboards only allow you to use SATA after you have declared your disk through the raid utility. Watch out when ...
...RAID functionality in the BIOS Setup Utility: 1.Boot the server, and then press F10 to enter the ROM-Based Setup Utility (RBSU). 2.Go to the advanced tab. 3.Enter the IDE configuration or hard disk ...
...that it is RAID 5 in your RAID config utility, and swap. It may take a larger drive, but you would lose the extra space. Util should indicate either way.Best practice is to use
Question about Icy Dock MB662USEB-2S 3.5 Inch 2 bay SATA for Mac & PC 2 TB FireWire 400 (1394a) Hard Drive
Raid 1. My Mac no longer recognizes the drives so I ran Disk Utility, selected the enclosure (which it recognised) and selected "verify disk". There was no response. I switched off, removed the backup
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions