Questions & Answers for: rag paper

...rag on the probally covered in paper dust feed roller. Location underneath with cassette out. Appearence larger Black Rubber cresent shaped roller inch wide front middle under. Use damp rag ...

ragged edges intermittent My almost new mp830 has a problem that causes the paper on output to be a little ragged on the lower half of the right edge. Of course this would be an intermittent problem ...

...paper above 190 grams feeds thru. sometimes pre feeding it works (once in ten times). Any idea? try to look at your rollers made of black rubber, if they are shining then they need cleaning, if you ...

paper from the tray. Have you tried to clean the pick up rollers with a rag with a small amout of WD-40 or Simple Green. Clean the roller then whip off with a dry rag. If the problem improves you need

...rag (read: not tissue or toliet paper) and liberally put Windex or glass cleaner on the rag until it is soaked. Rub the rag horizontally against the roller and spin it around to get the entire roller ...

...they need to be cleaned with a damp rag. You hold the rag against them 1 at a time and open and close the front door so they will rotate while you hold the rag on them. Should help the paper

...rag and wipe the rubber roller above where the paper is lifted, and also gently hold that damp rag on each of the exit rollers on top where the paper comes out as you open and close the front door to ...

paper size. Has anyone ever had this problem?? Any help would be fantastic! Thanks! :) Sure. One of the papers is probably clay based (Shiny) and one is rag based (rough and dull). Clay based produces

...into printer. Have paper in place. Spray a little wd40 in a on a rag and clean the rubber feed tire. Take the dry side of the rag and clean off the roller. Should feed good if not replace feed