Questions & Answers for: Yaesu radio err

yaesu radio transmitter receiver i have a yaesu radio in my boat since early 1995 hook to the battery line 12 volts 700 amps, now i want to install a second radio similar to the one in the boat in a ...

Yaesu VC-27 Does this earpiece mic have vox built-in or will it only work in vox mode with a radio that has vox included, such as the VX7? Hi Jon, If this is the earpiece that came with the radio &

MY YAESU 411E GOT OUT OF BAND WHAT SHALL I DO ? AFTER I CONNECTED RONG BSTTERY POSIONN IT SHOES FREQ. 280 INSTED OF 140 AND GIVE MR ERR SIGN WHEN TRYING T O TRANSMITE . IS IT POSIBBLE TO RESTART IT? ...

...installed and when I go to transmit the "ERROR" sign appears on the mike. How do I rectify this? Radio is brand new Hi John, Do you have the User manual? If so look under Trouble Shooting section, ...

FT 711RH, Radio gets very hot in receice mode, and will not show power output when mic in keyed Hi, To get a reading of your radios RF ouput, requires a dummy load test. I somehow doubt that this is ...

...the radio and starting from scratch but same result is the radio in duplex (offset transmit freq)if keying takes radio out of band it would show err,select simplex ie transmit/recieve same ...

my yasue ft25o radio will recive but will not transmit the other radio shows it is receiving the light comes on on both radios, what can I do to fix this? will receive but will not send, is the offset

My radio cuts out completely. Wait ! minute and repress the power button, radio back on. Radio runs flawless otherwise sounds like the power supply. Check all your connections and wires just in case. ...

Err" message when trying to transmit Yaesu FT-690RII 6 meter amateur radio transceiver Almost always a programming issue. Somehow, the transmit frequency is not enabled or programmed correctly. Always

...the fuses and the power supply. Make sure that the power supply has enough capacity to run the radio, at least 20A! Make sure that the power supply is putting out 13.6V. If you were unfortunate ...