Questions & Answers for: Midland radio control

.... could this be the driver or what Are you sure that you're on the AM mode? It sounds more like you're on LSB or USB. If you are on AM, the problem may be the power control (VR6) inside the

lazy signal needle i need to know which pot controls th signal meter so i can adjust itplz Probably NOT the potentiometer that assists the meter. I would suspect a abad needle in the meter. I'd see if

Tubes may be bad Radio want power up Tubes?? What Radio??

Audio is very scratchy/static If it makes a scratchy sound when the volume is turned up and down then the carbon contacts on the volume control are most likely the culprit you can attempt to clean ...

On channel 26 all I hear is Russian. Is there a bad chip in channel 26? Can you replace the channel 26 chip with one that picks up English? the channels is controlled by a crystal so no you can not...

...control in the mic. This is why the radio uses a six pin mic but it is an offset pin spacing. This is an extremely tough mic connector to find and the radio is getting pretty old. I have on several ...

...radio itself. This will be noticed if you can transmit, but have no "Modulation". Modulation can be described as the voice heard above the "Carrier" (your transmitted signal). Every CBer knows about ...

...control is not working ( I get lots of static) radio still works. Sends and receives, but when I turn the squelch control it makes no differance. what time of day are we talking here? usually skip is ...

...control on the radio to see if it stops. Hi Julie, I have seen this problem many times with radios that I have taken in for service. I need two way radio dealer who is very good with sales but not ...

I have an almost new Midland 75-822 that the WX works fine on, but the CB doesn't seem to receive, or transmit. It operates normally, but no reception, and no evidence of transmissions. I have an ...