Questions & Answers for: Mazda radiator cap

...radiator cap if it has one to allow air to pass through radiator, if it has no radiator cap remove the cap on the radiator expansion reserve tank, after all antifreeze is drained turn petcock drain ...

...radiator cap and first start the engine, water comes out of the top of the radiator fill. Your overflow hose is at the first tier after the seal on the radiator cap. The first thing I would check is ...

...radiator cap before removing the expansion tank cap, or when the engine is hot. Fig. 1: Remove insects and debris from the radiator fins Remove the expansion tank cap. The expansion tank should be ...

radiator cap pop off when the engine gets heated up too much in mazda 3? only if the cap is not properly tightened. otherwise the radiator caps are properly manufactured to withstand high pressures If

radiator cap on 91 protoge after the engine ran for 3 minutes, i opened the radiator cap and the cooling fluid overflowed This sounds normal. The coolant and any trapped air bubbles in the system will

radiator cap with the proper temp range.Check the rubber gasket on the cap used now.If the cap is not high enough pressurewise,temperature will force the coolant out.Rigger sayreplace the radiator cap

...incline since air will rise to the top. Open the radiator cap (do this only when engine has cooled down), next squeeze your upper radiator hose. Another way is to leave your radiator cap off, start ...

...radiator cap and refill until full; as the radiator fluid circulates throughout the system, the excess air will rise to its highest point which is the expansion tank or radiator cap. Most radiator ...

...radiator cap that's bad? Why wasn't this caught at the dealership? The cap can be at fault can happen any time check radiator every week . Have the cap and radiator pressure tested ,the car is 11 ...

...radiator cap or the radiator expansion tank cap and start the engine in idle and follow the water if is rotating. If not you have to check for your water pump if is working might have worn blades. ...