main flow control valve and the cleaning out of the heat exchanger,with no success. In fact after the APS was changed the hot water was on for even less time than originally so it was worse still. The
Main valve (Smart Valve SV9520H), how to test?) 2. Flame sensor?, how to test? 3. Glow Plug,(Hot surface igniter) how to test. I can be reached (shibobo2@juno.com) if you have any help for me ........
...main burners do not ignite, the flame sensor does not pick up the heat and says, "NO" to the main control board, Shut That Gas Valve and Main Burners Down! Thank God we have safety controls like the ...
...quot; sounds like you need to replace the thermocouple. this part is heated by the pilot flame and it sends a low voltage flame to the gas valve to open the main gas flow valve. they are very easy to ...
...main burners do not ignite, the flame sensor does not pick up the heat and says, "NO" to the main control board, Shut That Gas Valve and Main Burners Down! Thank God we have safety controls like the ...
...main burners - the pilot works but when I "turn it up" nothing happens not a single thing. Any ideas would be greatly appreciated and thanks in advance. Rob Is your pilot light blue with no ...
Question about Gas Dryer Flame Sensor 338906
...main flame will come on, and when the main flame reaches the cutoff point, it kills the pilot light also. I have to wait until the heater cools down to relight the pilot. I have drained the heater, ...
...quot;. Have two units side by side and the other is working fine. Replaced the FV Sensor, but cannot get heater to restart. Lights stay on. Tried turning breaker off and then back on. iIf main burner ...
Question about Gas Dryer Flame Sensor 338906
...to have flame?" Raypak RP2100 won't heat pool, seems that only main burner is working. What could cause only main center burner to have flame?" low gas pressure, clogged burner ...
Question about Gas Dryer Flame Sensor 338906
my blue flame heater has a sporatic yellow flame about 2 inches higher than the blue flame on the main burner. Both pilot and main burner have blue flame What is wrong ? Nothing is wrong
Usually answered in minutes!
307 Questions
294 Questions
248 Questions
202 Questions
187 Questions