Questions & Answers for: quick coupling Microwave Ovens

Whirlpool Microwave I have a built in Whirlpool microwave (integrated with the oven) Model RM280PX8O3. When I turn it on cook I get a loud buzz/hum followed by a blown fuse. It takes a couple of ...

...remove this Microwave from the fitted furniture. Many thanks in advance.. Hi there, Thanks for the quick reply. As you said this has been mounted into a recess and surrounded like a picture frame. I ...

...but just wanted as many ideas as i can get. thanks roxanne - 'ms middle's' mom Hydrated lime, or quick lime, available at most farmer's supply stores or garden centers will neutralize the acid in ...

ace 208 comes up with "hot" in display amana tech say not possible no code like this Hello I´ve repaired a couple of ACE208 with hot message in the display. The problem is in the convection fan ...

control panel and rotation work. Bad Smell like Whirlpool GT1195SH control panel and rotation work. Bad Smell like hot insulation on wiring when starting a cycle. No heating occurs. I have VOM ...

Defective KitchenAid microwaves causing dangers to lives Our KitchenAid microwave, model # KHMS155L-3, put my husband and I in danger, as well as our entire condo community in Seattle, Wa., when it ...

Intermittent Power Loss I have a Samsung SMH9187 microwave, that is just over 2 years old. The unit went dead couple of days back, no power at all, no clock, no keyboard power, no light. Checked the ...

quick test it to remove your tray and see if you can turn the coupling easily by hand, if you can you probably have a broken drive coupling. The turntable motor is very difficult to turn by its shaft.

Is there a way to reset my oven? It says the meat probe is plugged in and it is stuck on warming - I have NEVER used the meat probe! We have shut off the power overnight and then turned it back on ...

...a couple of screws remove the bottom on the microwave. a couple of screws hold the motor, and two quick connect wires. thats it. good luck. (if this is just a tabletop microwave maybe a new one ...