Questions & Answers for: Toyota quick boot

quick and dirty procedure. Basically, to adjust the distributor timing, you need to: 1. make sure cylinder 1's piston is at firing position/TDC (top dead center); 2. crankshaft pulley's timing mark is

quick fix, that may or may not help....Under your shifting boot, turn the collar that holds in your shifter, it should release, and let you take the shifter up. There is a plastic ball on the end, see

..., the procedure was to un-clip the boot from housing on the block and forcefully pull the shaft quickly and firmly and.....Whhhhhaaaallllaaaa!!. off she comes.Is the starlet the same

...boot up ok? Yes. The computer will store the memory for quite some time actually. It saves information each time the car shuts off. It has it's own backup source. Just your radio will need ...

...trunk and spare tire storage put a hose on it and check for leaks ,could be the rear screen or the boot lid seal.Quick solution is to drill a hole or two in boot spare wheel area to let the water ...

i am getting a loud rumble noise at the front end of my 94 automatic corolla 1.3L.I checked the wheel bearings by jacking thecar and rocking the wheels back and forth. everything seems nice and tight,

...quick boot that looks like a p.o.s. what is my best option here? Any tips on getting the axle out? hi. i always use the universal boots that you do not need to take the drive shaft out to fit. i have ...

... That was actually a pretty pleasant night, as I recall - it's not a horrible job. If you like, quickly verify - jack up one front wheel, turn the wheels far to either side, thoroughly chock both ...

depends on your remote. Some have separate button for the trunk and some you press the unlock twice quickly

quick squirt of WD40,Or sim, then apply a good finger full of a water proof grease, 2), Try to close the boot, & and with any luck, the latch in the lock will now be free and activate and the lock