Question about 1993 S-10 Blazer
...spark plug wires on 1993 S-10 Blazer with 4.3 V6 engine are attached to right connecting points on distributor cap. The firing order for a Chevy s10 depends on which engine you have. 1.9L engine the ...
1988 chevy s10 blazer 4.3, cut out while, will start but want stay started, getting gas and spark Your vehicle as an ignition control module located on top of the distributor (under the cap and rotor)
...a will a 1985 S10 Chevy blazer tilt steering collum fit a 1988 S10 Chevy truck yepper! lol i have owed 5 of this geneation and both the s-10 and blazer are identical in the dash, engin and drive ...
...fuel pump and spark plugs Wires distributor cap and rotor and it still wont run or idle. What do i do? Blow out fuel line put 3-4 cans of dry gas & try again might have injector problem ...
Question about 1992 Chevrolet Blazer S10/jimmy S15 Radio
...chevy s10 blazer 4.3 vortec not getting good fuel pressur replaced feul pump feul pump relay and pig tail its not leaking feul anywhere could it be a bad computer also replaced distributer and i know ...
...no spark who does my chevy s10 have no spark probably because your coil is bad or plug wires Check your ignition control module. It's in the distributor, if it cranks but won't spark it's a good
Question about 1996-2004 Chevy S10 Blazer Radiator w/ 4.3L and EOC
what casues misfire on number 4 cylander Bent or burned valves. A fouled spark plug. A bad spark plug wire. A bad injector.
Question about 1996-2004 Chevy S10 Blazer Radiator w/ 4.3L and EOC
Where is the bank 1 o2 sensor located on the 2000 Chevy s10 blazer The link below should show you the answer; How To Install Replace Upstream O2 Sensor Chevy S10 Blazer GMC Jimmy 4 3L Hope this helps.
Question about 1996-2004 Chevy S10 Blazer Radiator w/ 4.3L and EOC
s10 pickup Changing from a 4 cylinder fuel injected to a v6 throttle body what wires change You would be better off going to a auto salvage yard an getting a whole wring harness out of S-10 that had a
...plugs with wires on top goung into exhaust pipe they are o2 sensors ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions