Questions & Answers for: where you put the oil in a

...put a new oil pump in the car, and it still wont pump oil. We primed it with grease before we put it in, and the rod from the oil pump to up in the motor seemed fine. We put the oil pump in oil and ...

...oil do i put in a 2005 r1 i need a oil change in my 05 r1 how much oil do i put in it? i will be putting in full sythetic oil but dont know how much to put in. please help thanks the oil capacity is ...

...Put oil drain plug back in. Check owner's manual for oil capacity, put all oil in minus one quart. Start engine let run for aproximately 10 seconds. put in rest of oil and check dip stick to ensure ...

...put the oil filter in so it doesnt leak oil.ive been putting the oil filter in but dont no where to put the rubber ring so i havent been using the ring. well the ring should stay on the oil filter if ...

oil to put in engine. How many Quarts of engine oil does it need. if you can't detect oil level or usage, there's no way to determine how much oil to put in the car. you can drain it all and put in "x

...put the oil in a car on top of the motor where oil fill is if the oil is comming out where you are putting in underneath you have removed the oil pan plug Put the plug back in Then put the oil in oil ...

...put oil plug back in. Put 3- 31/2 quarts back into car. put oil cap on and start car. Let run for 2-3 minutes then shut back off. Wait for a few. Pull out dipstick wipe, put back in then pull out a ...

make sure you put the bolt back in the oil pan. Put a little new oil into the new filter and wipe some oil with your finger around the oil filter rubber gasket. Make sure you don't overfill with oil

took out.after doing this remove the oil filter and discard it. put on new oil filter and tighten as much as possible only hand tight. then put in the new oil. check for leaks, and thats it. good-day

...put new oil in it, turned it on again, and oil poured out again. noticed seal on oil filter was blown out a little bit. put it back in oil filter, put new oil in, turned it on, and oil poured out ...