Questions & Answers for: put bike gear rolls

put the bike in gear. It's like all breaks are mashed holding the bike still. It doesn't want to go anywhere. Thats how its suppost to be. Once its in gear and you try to roll it yourself then you are

put motorcycle in gear bike still rolls Clutch could be way out of adjustment or at the extreme your engine compression could be so low that the bike could roll in gear.

...bike then put in gear while it is rolling and it go? I would say adjust the clutch. Screw the adjustment out. Or unscrew the adjustment. Which is under a little black rubber boot on the clutch

...Put the bike in a high gear, take out your plug, put the bike on a stand then try to roll the rear wheel. If the wheel rolls, and you can feel air chugging out of the spark plug hole, the piston is ...

...put the bike in gear, with the engine off. Pull in the clutch and attempt to roll the bike around. Does it roll freely? If not, you may have to replace the friction disks in your clutch ...

...put the transmission in gear and try to roll the bike. If the bike rolls, you've probably got a busted belt or the splines in the front pulley are stripped out. You may even see a little oil drip ...

...put the bike in one gear lower than the top gear. You didn't say what year or model bike you have. If it's a five speed, put the transmission in fourth gear. Do a full throttle roll-on ...

...and stalls The PW80 does not have a manual hand lever clutch, its a 3 speed semi auto. The bike will jerk and shut off when put in gear. If I put it in gear while rolling then it will work. Any

...put in gear and roll back and forth with clutch released does engine stop the bike from rolling? Now pull clutch lever in and try rolling again is clutch cable adjusted properly? Electrical issue: ...

...bike slightly either forward or backward where there is some give, and put it back into "neutral" and drive off. It also wont go into 3 4 or gear 5, the shifter acts like there is no gears there and ...