...Use the 'ALARM ON' lever to adjust the time. Use the mode button to move from hours to minutes and repeat the same steps. Push the SET lever to set the time once all the required fields are
...push on setting lever point, 3) While holding setting lever pushed in- extract the setting lever by gently pulling crown out of watch. Do not forget to rate, please. I have pulled the crown by force ...
...push on setting lever point, 3) While holding setting lever pushed in- extract the stem by gently pulling crown out of watch. If this doesn't work- upload picture here. Do not forget to rate, please. ...
...movement from the back. The movement back panel has to be removed if it has one. If the levers are pushed toward the chime rods, they will silence the hour or musical chime, depending on which one
...Then close when done, and push the wind handle back in. At one oclock the lever is pulled out about 1/4" then you can set the time, when finished, push the lever back in. Hope this ...
...lever and it holds stem in place. Take fine pointed tweezers and push and hold on it (in hole or in the groove). Stem will come out while setting lever is pushed down only. In some watches setting ...
Question about Expedition 40141 Wristwatch
push the crown in to close it and screw it back to the normal wearing position it still changes the time as i screw the crown closed. I honestly just took it out of the package and removed the plastic
Question about Kinetic watch
...is quite rare. Does the button have a definite detente when you press it? Or is it instead like pushing on Jello. Is the button spring loaded such that it returns to the neutral state on its ...
Question about Kinetic watch
...push button in and release the stem 3. pull the stem out and a little lever will be seen by the stem, press that and the stem will come out 4. if quartz, will have a hole with a small arrow pointing ...
...push fit' back plate. *Note* If your using something metal as a lever it could scratch the watch. CAREFULLY using a blunt edged lever GENTLY lever the back plate off. This should reveal the battery. ...
Usually answered in minutes!
756 Questions
260 Questions
271 Questions
253 Questions
254 Questions