Questions & Answers for: push lever Vacuums

push the lever up to the Carpet setting. Thank you for any help you can give! You are correct. The belt is supposed to go around the peg that is connected to the lever so that when it is on the Floor

...lever causes the belt to push against itself when the vacuum is running.  If you push it all the way forward then move it back toward the back of the machine about 3/4 of an inch, the machine ...

...lever (push down) in the D position and it is a clutch assist to make it push easier. When unit is off, place in the N position to release the clutch and roll it around. Usually the plugs occur where ...

...use a screwdriver or two to press the plastic tabs back and then push the release lever out. The new release lever can be just pushed into place and the plastic tabs will snap and hold it in

...lever that you push to release the dirt cup. Since all models are different I can't tell where yours is at. If you can't find it, read the manual. If you don't have a manual, ask your momma. Look for ...

...reverse stitching, push lever in and slide it to the left to lock. Unlock reverse lever by sliding it back to the right and letting it return to its normal position. if you need a manual let me

refill water tank Cannot remove tank top push down and turn With the unit unplugged push down the steam lever and hold while pushing down and turning the cap..

...use a screwdriver or two to press the plastic tabs back and then push the release lever out. The new release lever can be just pushed into place and the plastic tabs will snap and hold it in

...Bought new in 2004. First make sure the hose or nozzle is installed properly so the switch lever is pushed in all the way. Then check the bag emptor to make sure it is pushed all the way in to engage ...

...begin Make sure the emptor at the. Bottom of the bag assembly is turned all the way clockwise. It pushes in on lever on the switch. It won't run if the lever is not pushed all the