...lever and that you can easily push them back into the caliper (after you disconnect the brake line). Then rebuild them if required and reinstall. have you checked you hoses for the antifreeze leak? ...
Question about 2003 YZ 125
...lever in, and try and change gear it feels like your foot will snap b4 it goes in gear,, if that makes sense,, firstly mate,is to make sure the clutch cable slides freely ,easest way is to take cable ...
...push lever (the shaft that goes into the side cover and the lever is attached to). The shaft is splined for the lever to attach. Re-fit the lever on the shaft and try it now. If the splines are ...
Question about 2003 YZ 125
...other because of oil check the clutch lever at the motor and make sure it is moving the arm that pushes the pressure plate and make sure it is moving with the engine off put the bike in first gear ...
...lever and i cant push the bike. it wants to go with the clutch engaged. the cable is pulling the clutch you can see it on the casing and its being pulled has far has it can be try adjusting clutch ...
...push lever assembly #24 from the shaft before installing the cover. Once you engage the teeth of #11 to the teeth on #19, the axle, push lever, you rotate #19 to "pull the outer cover onto the clutch ...
...push lever axle (I think this is what you are calling the main shaft) sits in a hole on the side cover. The gear on the axle engages the push rod and the push rod separates the clutch plates by ...
...push it and it will go can u help me find out whats wrong please Start by cleaning the carb inside and outside and also clean the air filter. Check for cracks in the reed valve and mounting joint ...
...lever, cable, arm the cable connects to inside the flywheel cover, the push rod, the pressure plate. I checked to make sure all the parts are there and they are, the 11/32 ball, washer, and bearing ...
Usually answered in minutes!
652 Questions
147 Questions
12 Questions
8 Questions
7 Questions
