Questions & Answers for: Volkswagen Beetle push lever

Question about 2003 Beetle TDI

1 Answer

...the bulb and then pop the light back in. You will have to push hard inorder to get the lever to go back down. We had better luck with two of us doing it... one pushing... the other working the

Ad

Question about 2000 Beetle

2 Answers

...push up the lever.Then go to your headlight and pull out light housing at the outside rubber. The lever only pushes out the housing about 1/4 of an inch. To access light remove from the rear of ...

Ad

Question about 1999 Beetle

1 Answer

Replacing both headlights - what is the trick to releasing the cylinder levers to remove the whole lamp assembly? Just gently push the column lever forward and it should pop out

Question about 2000 Beetle

1 Answer

...push the lever. There is a square locking tab right beside that lever that needs to be pushed in a bit releasing the lever from it's lock position. Don't push it in too deep, it will break. Once it ...

Question about 2000 Beetle

1 Answer

...push the lever. There is a square locking tab right beside that lever that needs to be pushed in a bit releasing the lever from it's lock position. Don't push it in too deep, it will break. Once it ...

...lever. Push the entire headlight casing out toward the front of the car. (The casing will hang over your bumper) Pull out the headlight and plug the new one in. Push the casing back in and lock the ...

...out Slide the lever upwards,Sometimes it takes some patience to get it to release.U may wanna try pushing inward on the front of the headlight while your pulling up on the lever.It may take slight ...

...Push down the tab and pull the lever to "spin" the ring. This will slightly push out the headlamp. Replace the bulb and place back in. Then "spin" the retaining ring the other way until the tab locks ...

Question about 2001 Beetle

2 Answers

...lever and then push it back up. Pull the headlight assembly forward and slide it out of your Beetle. Unplug the electrical connector from the backside of the assembly. Look toward the top part of the ...

Push the parking lever all the way down to disengage the switch if that doesnt work then pull the cover for the brake handle the switch is just below the lever u might have something stuck to it or ur

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...