Questions & Answers for: Kenmore push lever

...push the lever, it does not seem to have a problem going back and forth. I hear a click and the light turns on. Some additional information about refrigerator: I kept the temperature to cold and the ...

...push the lever over to the side. To raise them back, push the lever the opposite direction, back where they were originally. You will not actually see the feed dogs move until you turn the handwheel ...

...push the wheel it just hesitates. You must always make sure the takeup lever is just on the way down before you press on the foot control, with the takeup lever at the top the thread will be strong ...

push the lever up to the Carpet setting. Thank you for any help you can give! You are correct. The belt is supposed to go around the peg that is connected to the lever so that when it is on the Floor

...lever causes the belt to push against itself when the vacuum is running.  If you push it all the way forward then move it back toward the back of the machine about 3/4 of an inch, the machine ...

push the lever in and see if you hear a slight "click". If you do, set the timer to dry, push the start button WHILE PUSHING THE LEVER IN. If the dryer starts, the metal lever you are holding may have

...forward if your reverse is a lever then pull the lever down to normal sewing if it's a button, try pushing it several times & try to see if that will help it unstick if it doesn't use some wd-40 ...

...lever is raised? In the first 40 degrees of motion the lever does nothing to raise the foot, only pushes the horizontal bar to the upper tension system. Can the piece that rides on the top of the ...

...push the lever, right? So when you push the ice dispenser lever do you hear a "click" like you do when you push the water lever? Push them slowly and listen. If no "click" is heard then it is most ...

...lever on the left, or sometimes the right, toward the rear part of the base to push with your foot. Step on it while at the same time push it slightly forward first - just a quick 1" forward motion, ...