Questions & Answers for: John Deere push lever

...lever to push, it does not release the transaxle. it's like the thing is gear bound. i raised the back end of the tractor and i can turn the wheels (they turn in opposite directions) but if you ...

...push lever forward or back, tractor does not move.. Srx75 - lever to go forward or backward does not engage when pushed forward or backward check the lever on the rear of the tractor used to puch the ...

...PUSH THE GAS (FORWARD OR REVERSE) IT DOES NOT MOVE. IT ACTS LIKE THE BRAKE IS STILL ENGAGED. Hi, check back on the side of the transaxle where the brake spring is attached, the is a short lever there ...

...lever engaged. It's a small steel rod normally at the rear of the machine & should be pushed in to drive & out to allow the machine to be pushed

...push it to high, the cable is moving the lever on the front of the engine, but the throttle doesn't increase. It's a self-propelled type; the walking speed does work, just slow and ...

...lever, but didn't test battery but it seams to be ok. There are 2 safety switches on that unit as well. Most of them are right below the steering column in the firewall area. Search that to ...

...lever on back of tractor silver colour to pull out or push in does that have anything to do with engaging movement of tractor? Dont have manual sorry. Go to youtube . Type in your make and model/ ...

...will not operate. Locate the lever and try to push it in. If the lever is pushed in, the transmission is now engaged, and the foot pedals should activate the transmission forward and

...The throttle lever housing has 2 locking tabs on both sides. You might have to use a screw driver to depress the tabs. While depressing one tab at a time push the lever housing up until

I need to move it , but very hard to push. Is there a switch or lever to disconnect rear drive axle? in back there should be a lever that is a gold color on most pull it out and it should roll freely