...lever referred to above. I did notice the cartridge had some looseness in that you could push it up and down. So I -- 1. Unplugged the unit completely. 2. Removed the cartridge. 3. Re-installed same ...
...push canacel oly the media light is on .can you give me a solution as soon as possible plesa. thank you for your help It may one of the following, try these and see if you have any changes. If it ...
...on it, It would look like a small tab/lever that would move (to activate the switch) by the paper pushing against it. You would have to inspect this lever/switch and determine if it would move ...
Question about 1010 Plain Paper Inkjet Fax
push it with a finger but when you put in the cartridge it seems as if this spool winder is stopping the cartride from seating on the right because it isn't being pushed into the body by the cartridge
Question about 1010 Plain Paper Inkjet Fax
by finger if the sensor is in place.When you insert the paper tray into the printer,the paper stock pushes the sensor lever up.This is how most printers detect paper in the tray
...like torn paper. the sensing typically happens with little plastic levers. These levers get pushed out of position, and force a false indication. any dislodged lever needs to be put back, not ...
...push that lever.It should make a "click" sound.If the printer detects that the lever has been pushed down the message should go away.In that case the plastic that is located on the front door is ...
...is not it, then maybe you have a sensor or motherboard issue. Make sure the entire paper tray is pushed in or it will act that way. There are like 3 sensors that have to be activated in order to ...
Question about Pavilion dv5000z Notebook
I can't close PC card slot on hp pavillion -- either the PC card slot holder pops out or a little black lever Push the lever in all the way until it clicks then push in the holder.
Question about Pavilion dv5000z Notebook
...push the governor lever fully over so as to open the throttle fully, now with a pair of pliers rotate the centre shaft fully in the same direction as you have pushed the governor lever, then tighten ...
Usually answered in minutes!
2,817 Questions
2,162 Questions
1,869 Questions
1,584 Questions
1,504 Questions