Questions & Answers for: Harley Davidson push lever

...the lever is worn, the actuator moves aside and the brake light stays on. Remove the brake lever and push the little black switch. If the brake light goes out replace the lever and actuator. ...

My sporty 883 2007 don't start when pushed the start button, it has all lights good. I have to pull the clutch lever and starts inmediatly. What can i do? Evidently, Harley has added a safety switch ...

...and easy to replace. while you have the lever off check the brake switch for proper function- it should switch on and off easily with just a simple push and release of a small screwdriver or

...push the lever back then the light goes off...If this is the case then you caliper or braking needs to be looked as the spring mechanism that brings the lever back into rest position is not

...out and pull the lever off the splined shaft. Reposition the lever where you want it, push it back on the shaft, and reinstall the bolt. I hope this is what you wanted to know, Good Luck, ...

...How much up and down movement does the lever have? The plunger in the brake master cylinder pushes the lever back but the lever operates the front brake light switch. If the lever and

...and the rear brake lever. Both actuate the rear brake light. You can usually do a quick test by pushing the brake lever on the handlebar all the way out and see if the light goes out. This is

...on the bottom of the clutch pivot pin. Push the pin up and out of the clutch perch. Pull the lever out of the clutch perch. Push the white plastic dowel out of the cable and lever, and you are

...an "E" clip on the end of the pivot pin. http://lackof.org/taggart/hacking/supermicro-fan/e-clip.jpg Remove this clip, and you can push pivot pin up and out of the clutch

push up from the bottom, releasing the lever. BE CAREFUL, especially when reinstalling. There is a little "nub" for the front brake light switch (that operates/is pushed by the brake lever) that could