Questions & Answers for: pump switch

Question about Cyget In Ground Pool Pumps

2 Answers

SWITCH ON THE PUMP IS STUCK...WON'T START THE SWITCH ON THE PUMP IS STUCK ON, ON...PUMP SHUT DOWN AND I CANNOT MOVE THE SWITCH EITHER WAY...WHAT IS THE PROBLEM WHAT CAN I DO Replace the switch replace

Ad

Question about Cyget In Ground Pool Pumps

1 Answer

...or get a new switch switches are rated like 20-50 20-60 what is ur switch rated for ? if the switch doesn't kick out and pump just keeps running and running u either have a bad pump or ur sucking ...

Ad

Question about Rs-5 Remote Switch

1 Answer

switch to the pump, attached pump to drain line and put the pump in the basin. It started pumping immediately and did so for a long time until the water level finally dropped. Then, when it got to the

pump inertia switch.If the inertia switch is faulty then also fuel pump will not start.-------- The fuel pump relay on a 1995 Ford Explorer is in the power distribution box, in the engine compartment,

Question about 1995 Explorer

1 Answer

...switch on pump, and has to be reset. The switch you have on the pump with a reset lever is a low water pressure switch that will trip when a load is on the pump like a leak or no water in well and ...

Question about 1995 Explorer

1 Answer

...pump switch P/N 10-0034 installed in a water fall pond. The pond ran low on water and the switch turned the pump off. Now that the water is at the correct level the pump switch is still off. If I ...

...new wire to pump L1 lug the other side of switch gets the red wire going to other side and new wire to pump from switch to L2 and green to case or ground make sure motor is wired for 220 volt on ...

Question about 1995 Explorer

1 Answer

...pump switch on. If power on both, the wire from switch to pump must be broken. Run a new wire. If power into switch but none out-switch is bad. If no power into switch for the pump, may have to keep ...

Question about 1995 Explorer

1 Answer

...switch Pump will not shut off. Switch does not shut offmpowermto pump. Only way to stop pump is to turn off breaker. It sounds like the contacts in your switch have fused. What kind of pump are you ...

...pump from either switch. Try running to the pump a known 12 volt sorse directly to the pump,if pump is working check to see if power is running to the switch or switches,sometimes the switches are ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

David Spradling
David Spradling

Level 3 Expert

13524 Answers

Are you a Pool & Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...