Questions & Answers for: pump nozzle

...NOZZLE-PUMP HOSE NEEDS TO BE CLOSEST TO THE BLOWER HOUSING-I USED A VAC GAUGE TO TEST THE FUEL LINE-WHILE THE AIR PUMP WAS RUNNING-NO VAC-REVERSED LINES AND STARTED UNIT-ADJUSTED AIR PRESSURE-ALL IS ...

nozzle and see if it it pumping out fluid. If it is not, then the pump is bad and must be replaced. It it is pumping fluid then the nozzles are clogged. Use a fine needle to clean out the nozzles. You

one of the pipes from the nozzle and check if the pump is giving fluid, if not you will need to replace the washer pump, if it does the nozzles are blocked and you can use compressed air to clear them

...pump runs then the nozzles are blocked. Use a pin or needle to clear the blockage from the nozzle.(Stick it in the little hole pointed at the windscreen.) Be careful not to break the pin off in the ...

...nozzle fittings or air pump. The air pressure from the pump is no where near what you forced to the nozzle with an air compressor. You can push fuel past a plugged nozzle to get it to fire with your ...

pump end on the nozzle with the lever down (this is a common mistake as older pumps had to start with the lever up) 4. Push the end down on the nozzle and pull the lever up 5. If you hear air escaping

...pump nozzle have the the type of seal that fits tight against the filler neck? That seal has to be compressed so far for the pump to work properly. try to push the nozzle in further or pull back on ...

...pump to nozzle, nozzle may be clogged as well. The pump motor might run, but pump on the end faulty. Remove tubing from pump and see if it squirts out, if so replace tubing to pump and remove tubing ...

...pump when on,if so maybe clogged hose to nozzle or nozzle clogged up which you can clean chemical residues with a sharp needle then moderately blow air(with air hose) from nozzle towards end of hose ...

I have a flojet pump model #2100-848 used on a 20 gallon sprayer...just hooked up the sprayer after sitting all year and the pressure went all the way up past 100psi and blew the fuse...any ideas? ...