Questions & Answers for: Pontiac pulley diagram

diagram There is a tensioner pulley attached to an arm. Release the tension on the belt by undoing the pulley arm bolt, the belt will have enough slack to slide off the pulleys. To put it back on, you

the pulley system and put the new one on following the diagram. Crank the tensioner again and use a screwdriver to pull the belt over the uppermost pulley. Release the tensioner and check belt tension

...Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right. c. Using a Serpentine Belt Tensioner Tool or Wrench ...

...pulley is the only one left. Make sure to consult the routing diagram frequently during this step. If you route it improperly, you will have to either take it off and start over, replace whatever ...

diagram for instructions. 7 Rotate the tensioner pulley counterclockwise with the breaker bar and socket. Then, slide the new belt under the tensioner pulley. Slowly let the tensioner retract until it

diagram for 5 pulley belt 98 pontiac transport. need diagram to put belt on 5 pulley motor start from bottom crankshaft pulley and ac compressor turn belt tensioner counterclockwise or lift forward ...

...diagram for 5 bolt pulley for motor need a diagram on how to put belt back on the 5 pulleys look on the air cleaner or hood for a diagram if you can't find it the parts store will give you one ...

diagram for a 3.5L pontiac g6 gt I want to know which pulley is the alternator, crankshaft, water pump, ac, power steering pump, idler, tensioner and any other ones that I do not have the name of that

Pontiac Grand Am SE 3400 V6. Pulley identification for all drive belt pulleys on 3.4L SFI What are the specs for each pulley for the drive belt on the 3.4L engine for a Pontiac Grand Am SE 3400 V6 ...

...came apart an fell off. So I bought a new one and had it replaced. I want to make sure I have pulleys, all pulleys. I need a diagram please. Question edited for clarity. Question moved to model ...