...pulley and shreds belt with belt off check all pulleys and idlers for any play You have a pulley that has sharpened itself from a hard belt,and it is cutting the belts,look for a grooved pulley to be ...
...the idler pulley to make the belt slack. Some have a hole in it that accepts a 1/2 in. drive ratchet and you pull it to move the pulley. Others have a bolt head you put a wrench on to move the
...pulley,and use your same belt,now if the bearing in the ac clutch is the only thing wrong,have the bearing replaced on the ac compressor,it will cost about the same,the bearing at napa is about 25 ...
...either drive belt glazed worn or drive belt tensioner faulty causing belt slip or alternator, powersteering pump and water pump bearings going bad causing drive pulley drag cause drive belt to
...belt from the alternator pulley, let relax. In the center of the tensioner portion (not the pulley for the tensioner) there is a bolt. Remove the bolt and the tensioner. When installing new tensioner ...
...the tensioner, the van ran fine for 2 days and now the belt keeps slipping - any ideas? One of the pulleys or idlers is bad now that you have a new belt. Take off belt and check them
...conicity and fail if rotation is not maintain,so it always a good idea to replace the drive belt when you replace the pulley tensioner its the one that look silver ,with one bolt in the ...
...in the pulley bearing. No play is acceptable for and component pulley other than very slight play in tensioner pully. Ive seen A/C compressor and alternator pulley do that type of belt damage. ...
...keep it tight - the tensioner spring is damaged and its not keeping the belt tight - or one of the pulleys is not aligned with the
Question about 2001 Silhouette
Why does the new belt keep coming off down by the crank pulley? driven with other belt for 5-6 years what happened Has your belt tensioner gone bad?
Usually answered in minutes!
601 Questions
450 Questions
394 Questions
322 Questions
268 Questions