Questions & Answers for: Mazda 626 pulley belt

...attached to the belt turns. if one of the pulleys is seized and wont' turn properly, can overheat belt. 5. check pulley surface for cracks. must be smooth. 6. finally are your belts the correct

...belt. It somehow just would not go over the alternator pulley. I have fully retruded the alternator. It looks like the belt is too small even though it is the correct part. Do I need to remove the ...

...belt. Most tensioners have a area where a 1/2" ratchet or breaker-bar can be inserted to release the tension. The tensioner is nothing more than a spring loaded pulley, so look for the pulley that ...

...on one of the pulleys. 2005 Mazda : Question 1: Belt? or Timing Chain? Question 2: Tensioner pulley...Can it be tightened??? Question 3: When replacing tensioner pulley, cutting AC belt

...pulley's for sharp edges or bump outs into the belt. If you find anything use a small file and smooth them out. They can cut or pinch your belt and weaken it so it breaks over time. Check the pulley ...

...pulley and put the new belt on. I once owned one of these! Great car [at least I thought so] The biggest thing to look for when replacing the drive belts is to make sure all the pulleys turn freely ...

belt, reinstall the pulley making sure the new belt is "tracked" right according to the sketch you made before you removed it, retighten the compressor 10mm hex-head tensioner until there is between 1

BELT UNDER THE PULLEY. IF IT SLIPS FROM YOUR BREAKER OR YOU CAN'T HOLD IT YOU COULD BE SEVERELY INJURED. TRY MOVING AND SLOWLY RELEASING THE PULLEY BEFORE YOU ATTEMPT TO PUT THE THE BELT UNDER THE

...be a maximum deflection of .37" to .45 " ( 3/8 to just under 1/2") with a 22 lbs load applied on the belt . the tensioner pulley is then tightened up at the pulley nut to 28 -38ft lbs torque ...

...pulley and belt have been removed and I need to know how to set the timing marks. there should be tiny wee marks n the pulleys and on the block, line those little marks up put the belt on and tension ...