Questions & Answers for: Chevrolet Cavalier pulley belt

...of this pulley. Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley. Slowly release the tension. You're ...

Ad

...BELT TRACKS TO GO ALMOST OFF PULLEY ON POWER STEERING,TENSIONER STICKING 1/4 '' OUT OF ASSEMBLY TOWARDS FRONT OF CAR WHICH CAUSES THE BELT TO TRACK WRONG AND FRAY AND POSSIBLY COME OFF.NEED TO CHANGE ...

Ad

...Belt tensioner pulley, there is going to be a slot on the tension arm for a ratchet so you can take the tension off the old belt and slid it off the idler pulley or any one of the other pully's. Good ...

...pulley to loosen belt and the belt diagram is missing It should be the lower smooth pulley that the back of the belt rubs against. Torque it toward the front of the vehicle and it should relieve the ...

...tensioner. If the vehicle has A/C remove the drive belt from the A/C compressor pulley.Remove the drive belt. make sure the belt is aligned in the pulley grooves and in right position on every

Question about 1996 Cavalier

1 Answer

...tensioner pulley, push or pull on it making slack in the belt giving you enough slack to slip it on the last pulley. The belt is then under the tension created by the spring loaded tensioner

...pulley to loosen belt to get over last pulley. The bolt in pulley is turning but the pulley is not. turn bolt until it tightenc back up then keep pying the same direction (believe you are talikng ...

Question about 1996 Cavalier

1 Answer

...belt around the open pulley and move the tensioner pulley back into position. FINAL STEP Ensure that the belt is properly wrapped around all of the pulleys. The belt sits in the middle of the groove ...

...on until the belt is on every pulley except the tensioner pulley. Again, release tension on the tensioner pulley with the breaker bar, and then put the loop of the belt on that pulley and you're

...belt on the pulley system according to the belt path printed on the underside of the hood and next to the hood latch mechanism on your Cavalier. Leave slack in the belt around the tensioner pulley. 5 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...