Questions & Answers for: Nissan pulley belt

belt pulley a press fit on the water pump pulley or how is it fixed? On my car the alternator belt pulley is loose. Hi your alternator pulley is hold by a nut about twenty mm, chech it it may be lose.

Ad

...Belt Idler Pulley Adjustment Bolt (If equipped) (Part of 8678) 2 ? A/C Compressor Drive Belt Idler Pulley Tensioner Bolt (If equipped) (Part of 8678) 3 8678 A/C Compressor Drive Belt Idler Pulley (If ...

Ad

...belt over tension pulley last. another choice is ask at parts store and they will likely show you pulley and if u purchase a chiltons repair manual for your cars for around $25 it covers most basic ...

...belt pulley tensioner bolt. Loosen the A/C compressor drive belt idler pulley adjustment bolt. Installation CAUTION: Incorrect drive belt installation will cause drive belt failure. NOTE: Inspect the ...

Question about 2006 Frontier

1 Answer

belt and tensioner pulley but still getting belt noise when engine cold. Don't use a "belt dressing"... There may be oil or other substance on the pulleys. Remove belt and clean all pulleys .. inspect

belt the same way it was wrapped. Go over the crankshaft pulley; under the A/C compressor pulley; over the alternator pulley; under the idler pulley. tighten the adjusting nut from the top through the

Question about 1997 Maxima

1 Answer

...the negative battery cable. When replacing more than 1 belt, it is a good idea to make note or mark what belt goes around what pulley; this will make installation easier if you mix up the

...belt off the pulley be careful not to pinch your wrench on anything.once the tensioner has been released pull the belt out from around the other pulleys and replace with the new on pulling it around ...

...belt for compressor has pulley so follow #2 to remove it ,have to be done under the truck. First 2 belts will have to work around fan blades to remove them so wear gloves. After replacing belts ...

Question about 1997 Pickup

1 Answer

pulley the the belt runs around that is not part of any device. Put your ratchet on the center nut for that pulley in the on position. When you put pressure on the ratchet the whole pulley should move

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2000 Nissan Maxima
2000 Nissan Maxima

1,309 Questions

1995 Nissan Maxima
1995 Nissan Maxima

1,122 Questions

2002 Nissan Altima
2002 Nissan Altima

1,306 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...