...nut of this pulley. Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley. Slowly release the tension. You're ...
...belt on behind it. Between the Crankshaft pulley and the ac compressor pulley you will see another adjuster. Simply loosen the 14mm nut on the center of the pulley, then loosen the 14mm adjuster bolt ...
...Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right. c. Using a Serpentine Belt Tensioner Tool or Wrench ...
Question about 1993 Diamante
pulley, this makes the belt get loose, or theres bolts missing that hold power steering pump or tensioner on,remove the belts and take a good look at the crank pulley, the outter part of the pulley is
...pulley to loosen the tension of the belt. Remove the power steering/alternator belt. To install: Install the power steering/alternator belt first and then the A/C compressor drive belt. Adjust the ...
...pulley for the belt. 3 Loosen the bolt on the middle pulley with a socket wrench by turning counter-clockwise. Do not remove the bolt, just turn it a couple of times. Loosen the tensioner bolt on the ...
Question about 2008 Lancer GTS CVT Sedan
...pulley for the belt. 3 Loosen the bolt on the middle pulley with a socket wrench by turning counter-clockwise. Do not remove the bolt, just turn it a couple of times. Loosen the tensioner bolt on the ...
...pulley and remove the belt. The installation is the reverse of the removal. 3.0L DOHC, 3.0L SOHC Galant, and 3.5L Engines Fig. Serpentine belt routing-Mitsubishi 3.0L engines (except 1998-00 Galant ...
...belt tool on the tension pulley bolt and pull until the slack in the belt is gone. When there is no slack, keep the pressure on the pulley, and tighten the adjuster bolt with the wrench. Tighten the ...
Question about 2006 Pajero 3.2
...pulley. ... Belt squealing. ...Damaged bearing or pulley. Like the belt tensioner pulley, it's designed to remove that annoying belt vibration that's caused by excessive belt slack. The only ...
Usually answered in minutes!
997 Questions
851 Questions
799 Questions
747 Questions
704 Questions